Find great deals for Mxn07 V.1 AUO 15″ LCD Display. Shop with confidence on eBay!. MXNV1 Datasheet PDF Download – LCD MODULE, MXNV1 data sheet. : Brand New AUO 15″ LCD Panel MXN07 V1, High Resolution x, Aspect Ratio , Brightness Nits, CCFL Backlight, with Inverter.
|Published (Last):||17 July 2011|
|PDF File Size:||16.63 Mb|
|ePub File Size:||18.40 Mb|
|Price:||Free* [*Free Regsitration Required]|
Instead, press at the far ends of the CFL Reflector edge softly. Instead, press at the far ends of the CFL Reflector edge softly. Otherwise the TFT Module may be damaged. Please follow local ordinances or regulations for disposal. Search the history of over billion web pages on the Internet. CCFL inverter should be able to give out a power m150nx07 has a generating capacity of over voltage.
The average k150xn07 rate of the display module from 1, hours until 10, hours will not exceed 0. Cold cathode fluorescent lamp in LCD contains a small amount of mercury.
CCFL life time will drop dramatically if exceeding 8. CCFL life time 30,hr at 8. The average failure rate of the display module from 1, hours until 10, hours will not exceed 0. Long contact with water may cause discoloration or spots.
Full text of “Datasheet: Panel AU Optronics MXN07 V1 1”
Otherwise the TFT Module may be damaged. When the panel surface is soiled, wipe it with absorbent cotton or other soft cloth. Refer to figure as below. Definition of Response time: Item Unit Conditions Min.
Vin 0V 10ms max. No Reproduction and Redistribution Allowed.
Original M150XN07 V.1 15″ LCD DISPLAY PANEL M150XN07 V1 M150XN07V.1
The printed circuit board will be made from material rated V1 or better. N150xn07 signal characteristics are as follows: Note 3 Crosstalk at 60Hz 1.
Note 4 Contrast Ratio Full text of ” Datasheet: Brightness is measured at the center point of brightness value with all pixels displaying white. And m d is as follow. Note 3 Crosstalk at 60Hz 1. Interface signals are also shown in the chart.
Refer to figure as below. Display Area [mm] Small amount of materials having no flammability grade is used in the LCD module.
When mounted into a specified host system, the system will meet the following EMI requirement: This module does not contain an inverter card for backlight. This module does not contain an inverter card for backlight. A 0 0 cycle of rapid temperature change consists of varying the temperature from C to 60 C, and back again.
Thermal shock cycle C for 30min 0 60 C for 30min 0 Power is not applied during the test. Be sure to turn off power supply when inserting or disconnecting from input connector.
M150xn07 v1 v.1 15 au lcd screen
Only as for maximum white luminance, following criteria is applicable. Lamp units need voltage minimum for ignition Note 4: After temperature cycling, the unit is placed in normal room ambient for at least 4 hours before powering on. The actual UL flammability rating will be printed on the printed circuit board. Display Area [mm] Brightness uniformity of these 9 mm150xn07 is defined as below: Please follow local ordinances or regulations for disposal.